Basler BE1-CDS220, Instruction Manual

Page: 267 / 476

BE1-CDS220 ASCII Command Interface 11-9
Example 3. Read settings for all ports.
>SG-COM
SG-COM0=1200,P24,R1,X1
SG-COM1=9600,A0,P24,R1,X1
SG-COM2=19K,A156,P0,R1,X0
COMMAND SUMMARY
Miscellaneous Commands
ACCESS Command
Purpose:
Read/Set Access level in order to change settings
Syntax: ACCESS[={password}]
Example: ACCESS=CDS
Reference: Section 11, ASCII Command Interface, Miscellaneous Command Descriptions
EXIT Command
Purpose:
Exit programming mode
Syntax: EXIT - Note: Relay will prompt for verification
Example: EXIT
Reference: Section 11, ASCII Command Interface, Miscellaneous Command Descriptions
HELP Command
Purpose:
Obtain help on command operation
Syntax: HELP {cmd} or H {cmd} for help on {cmd}, H1 for command list
Example: HELP, H1, H SG-COM
Reference: Section 11, ASCII Command Interface, Miscellaneous Command Descriptions
Metering Commands
M Command
Purpose:
Read all metered values in primary or secondary units
Syntax: M[,P/,S] where P=primary, S=secondary
Example: M or M,S
Reference: Section 5, Metering
M-FREQ Command
Purpose:
Read measured frequency
Syntax: M-FREQ
Example: M-FREQ
Reference: Section 5, Metering
M-I Command
Purpose:
Read metered currents (I) in primary or secondary units
Syntax: M-I[G],[y] where y = P for primary, S for secondary
Example: M-I or M-IG or M-I,S
Reference: Section 5, Metering
M1-I Command
Purpose:
Read CT circuit #1 current primary or secondary units
Syntax: M1[-I[p][y]] where p = A/B/C/N/Q, y=P for primary, S for secondary
Example: M1 or M1-I or M1-IA
Reference: Section 5, Metering