Basler BE1-CDS220, Instruction Manual

Page: 454 / 476

C-2 Terminal Communication BE1-CDS220
Select VT-100 emulation.
Set the Backscroll Buffer to the
maximum setting of 500.
b. Click the ASCII Setup button. Make the
following selections using Figure C-3 as
a guide:
ASCII Sending
Place a check at Send line ends…
Place a check at Echo typed
characters…
Select a Line delay setting of 100 to
200 milliseconds.
ASCII Receiving
Disable Append line feeds… by
leaving the box unchecked.
Disable Force incoming… by leaving
the box unchecked.
Place a check at Wrap lines…
c. Click “OK”.
d. Click “OK”.
Step 8: Click File and click Save.
Figure C-3. ASCII Setup Dialog Box
Step 9: HyperTerminal is now ready to communicate with the relay. Table C-1 describes the required
connection for each RS-232 port.
Table C-1. RS-232 Communication Ports
Connection Type
Front Port 9-pin female DCE
PC to Front RS-232 port cable Straight
Rear Port 9-pin female DCE
PC to Rear RS-232 port cable Straight
WINDOWS

TERMINAL
Step 1: In Program Manager, open the Accessories program group and double click the Terminal icon to
start the program.
Step 2: On the menu bar, select Settings/Terminal Emulation.
a. In the dialog box, click DEC VT-100 (ANSI).
b. Click “OK”.
Step 3: Select Settings/Terminal Preferences.
NOTE
Settings changes do not become active until the settings are saved.