Basler BE1-CDS220, Instruction Manual

Page: 343 / 476

BE1-CDS220 Testing And Maintenance 13-29
Step 2. To prepare the 87 elements for testing, transmit the commands in Table 13-13 to the relay.
Table 13-13. Pickup Test Commands
Command Purpose
A= Gain access
SL-N=NONE Zero out custom logic settings/overwrite with
logic = none settings
Y Confirm overwrite
SL-N=RDIFF Name custom logic for this test
SL-87=1,0 Enables 87
SL-VO1=87RT Enables OUT1 to close for 87 restrained trip
SG-CT1=1,WYE,NA ctr=1, ct=wye, xfmr=na
SG-CT2=1,WYE,NA ctr=1, ct=wye, xfmr=na
SG-TRIGGER=87RT,
7RPU,0 Enable 87RT to log and trigger fault recording
E Exit
Y Save settings
Step 3. Send to the relay the commands listed in Table 13-14.
NOTE
The tap settings listed in the S#-TAP87 command are within the range of settings for a 5
ampere sensing input type relay. If your relay is a 1 ampere sensing input type, change
the TAP 1 and TAP 2 values to 1.0.
Table 13-14. S#-87 Commands
Command Purpose
A= Gain access
S#-TAP87=MANUAL,
5.00,5.00 Set TAP 1=5.00 and TAP 2=5.00
S#-87=0.1,15,0,0,0,1 Minpu = 0.1, slope = 15%, 2
nd
= disable, 5
th
= dis-
able, URO = disable, 2
nd
harm sharing = 1 (yes)
E Exit
Y Save settings
Step 4. Apply current to phase A, input 1 and slowly ramp up until OUT1 closes. The relay should
pickup at a value of minimum pickup x TAP (see Figure 13-12).