Basler BE1-CDS220, Instruction Manual

Page: 114 / 476

5-2 Metering BE1-CDS220
BESTCOMS Metering Screen
Metered values are viewed through the BESTCOMS Metering screen (see Figure 5-2). To open the
Metering screen, select Metering from the Reports pull-down menu. To begin viewing metered values,
select the Start Polling button in the bottom right of the screen.
Alternately, metering can be performed through the use of the ASCII command interface or HMI using
screens \METER\CRNT and \METER\DIFF.
Figure 5-2. BESTCOMS Metering Screen
ASCII Command and HMI Screen Cross-Reference
Refer to Table 5-2 for a list of ASCII commands and HMI screens used for metering.
Table 5-1. ASCII Command and HMI Metering Cross-Reference
Metering Function ASCII Command HMI Screen
All metered values M \METER
Frequency M-FREQ \METER\CRNT
Current, all values M-I \METER\CRNT
Current, Circuits 1-2 M1, M2
\METER\CRNT\CT_1-2\I_MEAS and
\METER\CRNT\CT_1-2\I_CALC
Current, Circuits 1-2 M1-I, M2-I \METER\CRNT\CT_1-2\I_MEAS
Current, Circuits 1-2, A-phase M1-IA, M2-IA \METER\CRNT\CT_1-2\I_MEAS
Current, Circuits 1-2, B-phase M1-IB, M2-IB \METER\CRNT\CT_1-2\I_MEAS
Current, Circuits 1-2, C-phase M1-IC, M2-IC \METER\CRNT\CT_1-2\I_MEAS
Current, Circuits 1-2, Neutral M1-IN, M2-IN \METER\CRNT\CT_1-2\I_CALC
Current, Circuits 1-2, Negative-Sequence M1-IQ, M2-IQ \METER\CRNT\CT_1-2\I_CALC
Current, Ground M-IG \METER\CRNT\GND
Differential Currents, all values MD \METER\DIFF