Appendix D – Application examples
490
Example – Position system commissioning
In order to commission the position system properly, you must check and configure
the settings of the following position parameters. Upon the start of the
commissioning procedure, these parameters must be at their default values.
Commissioning procedure
1. Parameter
2. Parameters in groups
for encoder configuration
3. Parameter
4. Parameter
5. The rest of the parameters in group
, except for the load encoder gear function
parameters (See the next step.)
6. Parameters
and
for load encoder gear function
7. The rest of the positioning parameters in groups
8. Parameter
9. Last, execute the homing procedure, if needed.
Summary of Contents for ACSM1 Series
