GE Healthcare eXplore Locus SP, Руководство по обслуживанию

Страница: 184 / 266

GE H
EALTHCARE
D
IRECTION
5158821-100, R
EVISION
3
E
X
PLORE
L
OCUS
SP S
ERVICE
G
UIDE
Page 184
13. Repeat steps 11 and 12 above (correct, unwarp & load into MicroView) for the shim2 file.
14. Make a note of the x value of the centre of the bebe using MicroView’s Region Grow tool, in
the Worksheet.
Note: The x values must be within 2 pixels of each other (e.g. if one value is 1140, the other must be
within 1138 to 1142).
If the values ARE NOT within 2 pixels of each other:
15. Place shims behind the elevation rail (loosen stage bolts, etc.). Tighten the screws to a torque
setting of 25 in/lbs.
Note: One pixel is approximately .002" in shims. If the x value of the top bebe in Fluoro is less than the x
value of the bottom bebe, the shim goes on the bottom of the stage. If the x value of the top bebe
is higher, the shim goes at the top of the stage.
The shims are placed close to the
mounting bolts. Larger adjustments
(more than 0.004") will require shims at
both the top
and the bottom to allow the
stage to tip once it is tightened (e.g.
large shim on the bottom and small shim
on the top). This is because flat surfaces
are bolted together.
NOTICE
Equipment
Damage
Possible
Failure to provide a tip relief will cause the rail
assembly to bend when the bolts are tightened
.
There should be at least 0.001" clearance at the tip
end
.
If you have to shim the stage, re-check the stage
tilt mechanically using the 9" Square.
Repeat steps 3 to 13 until the values are
or - 2 pixels.
Shims
Stage Outer
Bracket
tip relief
no tip relief
shims
0.001"