Festo CMMT-ST-SW, Оригинальное руководство пользователя

Страница: 78 / 616

The "Parameter list" parameter panel is always displayed in a table view. Switchover to page view is
not possible.
2.4 Diagnosis
2.4.1 Interface
Toolbar
In addition to the standard commands, the toolbar contains the following commands for the "Diagnos-
is" context:
Designation Function
"Start trace"
Start currently configured recording on the device.
The command can be executed if the following prerequisites are
met:
–
The plug-in is connected to a device.
– No recording is currently being performed.
If a recording is active or the device is waiting for a trigger, an
information symbol is displayed over the deactivated "Start trace"
button.
"Read trace"
Read out recording from the device.
The command can be executed if the following prerequisites are
met:
–
The plug-in is connected to a device.
– Recordings are available.
Tab. 44 Additional commands of the "Diagnosis"context
2.4.2 Device state
During an active device connection, the "Device state" diagnostic panel displays the current status of
the servo controller and axis and the message directory.
List of all diagnostic messages
è 9.4.6 Diagnostic messages with information for fault clearance.
Additional information on the message directory è 9.4.3 Message directory.
Additional information on the category
è
9.2 Classification of diagnostic events.
Additional information on the status of messages è 9.4.1 Status of messages.
CMMT-ST Plug-in
78 Festo — CMMT-ST-SW — 2019-02