Festo CMMT-ST-SW, Оригинальное руководство пользователя

Страница: 74 / 616

Section/command Description
If another device has the master control, an information symbol is
displayed over the deactivated command "Control".
The tool tip for the command "Control" contains the IP address
and the port number of the device.
Function:
–
Release final stage of the servo drive
The scroll bar shows the current setting.
The command can be executed if the following prerequisites are
met:
–
The plug-in is connected to a device.
– The plug-in has the master control.
– The device is not in error status.
"Powerstage"
During activation of controller enable, a check determines whether
a reinitialisation is required. If a reinitialisation is required, a
query is displayed offering the following options:
–
"Ok": The reinitialisation is executed and controller enable is
activated.
– "Cancel": The reinitialisation is not executed and controller
enable remains deactivated.
If another plug-in has the master control, an information symbol is
displayed over the deactivated command "Powerstage".
The tool tip for the command "Powerstage" contains the IP
address and the port number of the device.
Function:
–
Send stop command to the servo drive (category 2 stop)
"Stop"
The command can be executed if the following prerequisite is met:
–
The plug-in is connected to a device.
– The plug-in has the master control.
– Controller enable is activated.
Function:
–
Acknowledge all cancelled current diagnostic messages for
the servo drive.
Additional information
è
2.4.2.
"Acknowledge all"
The command can be executed if the following prerequisite is met:
–
The plug-in is connected to a device.
– The plug-in has the master control.
Tab. 42 Description of the toolbar symbols for motion control
CMMT-ST Plug-in
74 Festo — CMMT-ST-SW — 2019-02