Conair HTC 120, Руководство пользователя

Страница: 140 / 330

3-110
l I n s t a l l a t i o n - Te s t i n g
Configuring the DM-II Dr ying
Monitor
Setting Up the Drying Monitor-II (DM-II)
The EnergySmart Dryer control ships with the DM-II monitor software installed,
however, all of the functions are turned off by default to avoid nuisance alarms
created by improper setup.
To activate the DM-II monitor:
•
Set the dryer process air temperature;
•
Select an RTD for the alarm setpoint; and
•
Select the low temperature RTD sensor. (See the instructions supplied with the
DM-II monitor for more details).
Selecting the low temperature RTD sensor will automatically engage the DM-II.
Once the low temperature RTD is selected, the control will alert the operator if the
appropriate drying temperature is not reached within four (4) hours (default time).
NOTE:
If a change is made to the HTC or GasTrac, the DM-II will need to be reset. For more infor-
mation, refer to the supplied DM-II User’s manual.
Configuring the Level
(optional)
The optional level switch sensor monitors the amount of material inside the CH
Hopper and indicates to an optional receiver that a load cycle is required. If the
probe is not configured correctly, material level readings will be inaccurate.
Refer to the level switch’s manual for calibration instructions.
NOTE: To understand the
navigation of the DM-II
control, see the Control flow
diagrams contained in the
supplied DM-II User's man-
ual.
✐
✐
NOTE: Option must be enabled in Alarm Setup screen.
✐