Conair HTC 120, Руководство пользователя

Страница: 112 / 330

Connecting the Energ ySmart
Control to System Components
(continued)
Connecting the Optional Vacuum Pump(s)
The EnergySmart Drying System control sends a start signal to the optional
vacuum pump(s) when it receives a load signal from the optional receiver(s)
mounted on top of the CH hopper or auxiliary hopper.
CAUTION: Always disconnect and lock out the main power sources before mak-
ing electrical connections. Electrical connections should be made only by quali-
fied personnel.
To connect the vacuum pump to the EnergySmart Dryer electrical panel:
1
Disconnect and/or lock out main power to the EnergySmart Dryer and
vacuum pump.
2
Determine the location of the entry port on EnergySmart Dryer’s electri-
cal panel for the vacuum pump wires.
Open the door of the EnergySmart
control panel.
3
Drill or cut the entry port.
3b
If using electrical conduit, cut entry port and then run customer supplied
conduit from the EnergySmart Dryer’s electrical enclosure to the vacuum
pump.
4
Insert the pump wires through the entry port on the dryer’s control
panel.
Secure the wires with an appropriately-sized strain relief.
5
Connect the wiring to vacuum pump
as detailed in the supplied wiring
diagram.
6
Connect the wiring of the vacuum pump to the EnergySmart Dryer
electrical panel
as detailed in the supplied wiring diagram.
7
Repeat the procedure above when adding an additional vacuum pump
.
IMPORTANT:
Always refer
to the wiring diagrams that
came with your vacuum
pump and EnergySmart
Dryer before making
electrical connections.
✐
NOTE:
Conair recommends
the connections between the
EnergySmart Dryer and sys-
tem components should be
made with properly sized
conductors and properly pro-
tected with appropriate con-
duit (customer supplied). The
routing should be neat and
away from potential mechani-
cal damage.
(continued)
3-82
l I n s t a l l a t i o n - C o n t r o l & C o m m u n i c a t i o n W i r i n g