Xerox WorkCentre 5790 Series, Service Manual

Page: 1493 / 1610

May 2013
6-109 Xerox® WorkCentre® 5790 Family
dC314, dC330
General Procedures/Information
• Hop count to device.
Procedure
1. Enter diagnostics, GP 1 .
2. Select, Network Routines, dC314 Network Connectivity Test.
3. Touch the appropriate test button.
NOTE: The feature button is grayed out and disabled for unavailable protocols.
4. Touch Start Test and follow the on-screen instructions.
dC330 Component Control
Purpose
To show the status of input components e.g. sensors, and to energies and exercise output
components e.g. motors, solenoids.
Description
Output and input component codes are entered into the Component Control Table on the UI,
and then energized individually or in permitted groups. The codes in the tables are grouped in
function chain (
GP 2 ) order.
Go to the appropriate procedure:
• Input Components
• Output Components
Input Components
When the appropriate code is entered the status of the component will be shown on the UI.
NOTE: The logic level shown on the circuit diagrams with the signal name will be the actual
signal as measured with a service meter. This will not necessarily be the same as the logic
state shown on the UI, especially where the output is inverted. When testing components using
these control codes, look for a change in state, not for a high or low.
The displayed status of the input component can be changed by causing the component status
to change, e.g. operating a sensor with a sheet of paper. When a sensor is operated a beep
will sound.
Go to the appropriate table:
• Table 1 Input codes 01
• Table 2 Input Codes 05
• Table 3 Input Codes 06
• Table 4 Input Codes 07
• Table 5 Input Codes 08
• Table 6 Input Codes 09
• Table 7 Input Codes 10
• Table 8 Input Codes 11
• Table 9 Input Codes 12
• Table 10 Input Codes 14
Output Components
When the appropriate code is entered, the component will energize for a set time and then stop
to protect the components. The default time-out for most components is set at 90 s, but can be
as short as 5 s. Some components require that other components are energized at the same
time and it is possible to enter and energize up to six component control codes (not fax), but
only in permitted groups. If illegal combination of codes are entered the illegal codes will not
energize.
Go to the appropriate table:
• Table 11 Output Codes 04
• Table 12 Output Codes 05