65
SKYROS Corporation VideoNet 8.4 User guide
Select this option, if you want the system to perform the before started
reaction under a command of monitor selection or camera selection
from the system controller. In this case the system will understand the
command of switching to a certain screen mode as an
event
. For the
reactions
to be executed, it is necessary to add the corresponding
event and reactions to it to the schedule.
System schedule setup for working with system controller is described
in
3.7.2.5
section.
Attention!
For
Panasonic WV-CU650
model of system controller it
is not required to perform additional setup of system schedule, that’s
why there is no
«Send commands to schedule»
check-box on the
Setup
tab in
Panasonic WV-CU650
system controller properties.
3.1.2.13. SW RS videoswitch
You can add
SW RS videoswitch
into the system configuration using the
Add
device wizard
(see
3.1.2.2
section).
During adding
videoswitch
cannot be detected by means of
automatic
device
search.
To add videoswitch into configuration and to connect it to video capture device:
1. Select a free input of video capture device in the
device tree
.
2. Launch the
Add device wizard
.
Attention!
PowerVN8
and
TitanVN16
audio/video capture cards don’t support
connecting videoswitch to them.
After adding a
videoswitch
into system configuration it is necessary to configure
its properties (see the algorithm of
3.1.2.4
section). You can set up
videoswitch
properties on
General
and
Setup
tabs. Configuring devices parameters on the
General
tab is described in
3.1.2.4
section.
Setup tab
On the
Setup
tab you can
specify
number of inputs
(up to 40 inputs) and
outputs
.
In the
COM port
group
box you can specify
COM
port
and also device
index
for the device
indentification in case
there are several devices
of that type, connected to
one COM port.
