SKYROS Corporation VideoNet 8.4 User guide
266
3. Enter
port number
into corresponding edit box.
4. Click
OK
.
It is strongly recommended to select ports according to recommendations of
local network system administrator. This helps you to avoid problems in the
future.
To edit port number:
1. Click
Properties
button on the toolbar.
2.
Port number
dialogue box opens.
3. Enter new
port number
in the corresponding edit box
4. Click
OK
button.
To remove port number:
1. Select
port number
, you want to remove.
2. Click
Remove
button on the toolbar.
3.8.3.3. Configuring routing parameters
VideoNet
system enables to route information flows and thereby to optimize, if
necessary, utilization of low-bit-rate channels. Let’s demonstrate advantage of
routing usage with an example.
Let us assume that there are two communication channels – low-bit-rate channel
(with capacity of 256 Kbit/sec), for example, Internet, and high-speed data channel
(with capacity of 10 Mbit/sec), for example, LAN.
The task is to receive video information from CCTV camera of “Computer 1”, with
which connection is established via low-bit-rate channel, simultaneously by two
computers – “Computer 2” and “Computer 3”, which are joined in a local network
(connection between these computers is established via high-speed channel).
We can organize data transmission by two ways:
1) without use of routing (see
Picture 3.8.3-1
);
2) with use of routing (see
Picture 3.8.3-2
).
Attention!
In versions, lower than
VideoNet
Service Pack 3
the port 5010
was added by default. When updating old versions with
Service Pack 3
this
port will be automatically replaced by port Nr. 37395.
To add new port number:
1. Click
Add
button on the toolbar.
2.
Port number
dialogue box opens:
