355
SKYROS Corporation VideoNet 8.4 User guide
Attention!
If after camera selection,
«No signal»
inscription appears on
video window
, then most likely there is no video signal, because this camera
is switched off or connection cable is defective. Refer to system administrator.
If after camera selection,
«Error»
inscription appears on
video window
,
then most likely the error occurred because of incorrect devices setup. Above
the inscription there is usually the reason of error, for example,
«Error at
frame capturing»
. Refer to system administrator.
If after camera selection,
«Error»
inscription appears on
video window
and
above it there is the following reason:
«Refusals audit»
, then most likely you
have no right to translate video by this camera. Refer to system administrator.
?
To provide correct translation in video window it is necessary to add at least one video
capture device to system configuration. Also cameras must be added and connected to
it (this is performed by system administrator, refer to
3.1.2.2
section). Besides, it is
necessary to configure rights of access and camera control (this is performed by
system administrator, refer to
3.6.2.5
section).
You can easily start translating video in
video window
by any camera, placed both
on your computer and on other network computers.
To start translating video from CCTV camera:
1. Open
source selection menu
.
2. Click
or
button depending on view
type, you want to use at source selection (refer to
4.2.1
section).
3. Select
camera
, from which you want to translate
video, by left-clicking it in the list.
After camera selection and before receiving signal
from it there can appear
«Waiting»
inscription on
video window.
4. Video translating from selected camera starts in
video window
. During that, name of translated
camera will appear in
video window
top-left
corner.
B.
1. We should open folder, where we want to place sources, located in the
corresponding building.
2. We should select necessary sources. To select sources and place them to
the folder, it is necessary to make
steps 5-9
from 2 algorithm, listed earlier
in this section.
Now you can always easily select sources, located in the certain building
and gain access to the translation from that sources, by selecting folder in
the user view.
4.2.2. Translating video from camera
