221
SKYROS Corporation VideoNet 8.4 User guide
Description
Select user event from the drop-down list.
Select this check-box, if you want the system to register all the
operator’s commands in the
Event Log
. This option selection enables
you to control system operator’s actions in case of necessity.
Option
Event
Add message to
the Event Log
• Sensors signal
You can add this
event
type to system
task
, if you want the system to state signals
from sensors of a specified device.
Open event
Properties
dialogue box (see the
steps 1-3
of the algorithm of
3.7.2.8
section). You can configure
event
properties on the
General
tab.
For sensors controllers of
Power
family and for
TinyVN4 Pro
,
TinyVN4
Pro3
sensors controllers the maximum possible amount of sensors to be
connected is 16. For sensors controllers of
Titan
family the maximum possible
amount of sensors to be connected is 32.
Attention!
Sensors can be connected to above listed sensors controllers
using additional
MBRio
or
MBRio 2
cards. For correct configuring
Sensors
signal
event it is necessary before to specify in the controller properties the
type of
MBRio
card, used for sensors connecting (refer to
3.1.2.5
section).
system configuration. For example, if you want the system to start video recording
by operator’s command, you should create a user event on the
Screen
panel
(refer to
3.3.4
section), then add
user event
into system schedule and add
Video/
audio data recording
reaction for it
(this reaction will be described further).
Open event
Properties
dialogue box (see the
steps 1-3
of the algorithm of
3.7.2.8
section). You can configure
event
properties on the
General
tab.
Description
Select sensors controller from the drop-down list (if there is
no desiredcontroller in the list, you should add it to system
configuration on the Devices panel, refer to
3.1.2.2
section).
Specify the controller input, to which sensors are connected.
Specify the reason of the signal: sensor alarm or sabotage.
Option
Controller
Input
Reason
