217
SKYROS Corporation VideoNet 8.4 User guide
For example, if you want the system to perform some actions daily from 10.00
till 15.00 and from 17.00 till 19.00, you should add two
Time interval
events
with the corresponding setting into the event folder.
• Input video signal loss
You can add this
event
type to system
task
, if you want the system to establish a
fact of video signal loss on input of a certain camera in case the time of video
signal absence exceeds the specified interval.
Open event
Properties
dialogue box (see the
steps 1-3
of the algorithm of
3.7.2.8
section). You can configure
event
properties on
General
tab.
Description
Select type of time interval:
Once, daily, weekly, continuously
.
Select time interval:
24 hours
or
select
.
For
selective
time interval it is necessary to specify its start time and end
time. When choosing
daily
type of time interval you can specify less interval
end time than its start. In this case time interval will come to the end next day.
When choosing
weekly
type of time interval you should select those days
you want to start an interval with and also specify the start and end time. It
is possible to specify end time less than start time. In this case time interval
will start on the specified day and at the specified time and will end at the
specified time next day.
Note
. When specifying end time less than start time, the system will display
warning:
«Attention! Interval ends next day»
.
Option
Type of time
interval
Interval
Open event
Properties
dialogue box (see the
steps 1-3
of the algorithm of
3.7.2.8
section). You can configure
event
properties on
General
tab.
Description
Select camera, loss of video signal with which you want to state.
Option
Camera
