SINAMICS G120D
List Manual (LH14), 01/2016, A5E33842313
401
2 Parameters
2.2 List of parameters
Note:
The individual bits are only set if the appropriate action has been initiated and successfully completed.
When motor rating plate parameters are changed, the final display is reset.
Description:
Displays the base voltage for the alternating voltage in the context of motor data identification.
0:
No alternating voltages. The function is de-activated.
<0:
Automatic determination of the base voltage and wobbulation / self-setting based on the converter and the connected
motor.
Otherwise:
Base voltage for alternating current generation in volts (wobbulation active).
Description:
Successfully completed component of the last motor data identification carried out.
Dependency:
Refer to: r3925
Note:
The parameter is a copy of p1909.
12
Automatic parameterization as dynamic
drive control
Yes
No
-
15
Motor equivalent circuit diagram parameters
changed
Yes
No
-
r3926[0...n]
Voltage generation alternating base voltage amplitude / U_gen altern base
Access level:
4
Calculated:
-
Data type:
FloatingPoint32
Can be changed:
-
Scaling:
-
Dyn. index:
MDS
Unit group:
-
Unit selection:
-
Func. diagram:
-
Min Max
Factory
setting
- [V]
- [V]
- [V]
r3927[0...n]
Motor data identification control word / MotID STW
Access level:
3
Calculated:
p0340 = 1
Data type:
Unsigned32
Can be changed:
-
Scaling:
-
Dyn. index:
DDS, p0180
Unit group:
-
Unit selection:
-
Func. diagram:
-
Min Max
Factory
setting
- - -
Bit field:
Bit
Signal name
1 signal
0 signal
FP
00
Stator inductance estimate no
measurement
Yes
No
-
02
Rotor time constant estimate no
measurement
Yes
No
-
03
Leakage inductance estimate no
measurement
Yes
No
-
05
Determine Tr and Lsig evaluation in the time
range
Yes
No
-
06
Activate vibration damping
Yes
No
-
07
De-activate vibration detection
Yes
No
-
11
De-activate pulse measurement Lq Ld
Yes
No
-
12
De-activate rotor resistance Rr
measurement
Yes
No
-
14
De-activate valve interlocking time
measurement
Yes
No
-
15
Determine only stator resistance, valve
voltage fault, dead time
Yes
No
-
16
Short motor identification (lower quality)
Yes
No
-
17
Measurement without control parameter
calculation
Yes
No
-
18
After motID direct transition into operation
Yes
No
-
19
After MotID automatically save results
Yes
No
-
20
Estimate cable resistance
Yes
No
-
21
Calibrating the output voltage measurement Yes
No
-
22
Only identify circle
Yes
No
-
23
De-activate circle identification
Yes
No
-
24
Circle identification with 0 and 90 degrees
Yes
No
-
