Parameter Reference
D-33
AC30 series Variable Speed Drive
Configure, (Phase Control)
Parameters::Phase Control::Configure
Used to select Master and slave encoder source.
Gives a diagnostics of the configuration related to the encoder selection for the motor control, the Master ( Reference ) and the Slave.
Parameter Name
No.
Path
Default
Range
Units
Writable
Master Position Src
1745
Parameters::Phase Control::Configure
3
0:MAIN SPD FEEDBACK
1:SYSTEM BOARD SLOT 1
2:SYSTEM BOARD SLOT 2
3:NONE
STOPPED
Specifies the encoder to be used as the Master, (Reference) input :
MAIN SPEED FEEDBACK
: corresponds to the I/O feedback option
SYSTEM BOARD SLOT 1
: corresponds to the Slot 1 of the system board option
SYSTEM BOARD SLOT 2
: corresponds to the Slot 2 of the system board option
NONE
: no Master selected
Slave Position Src
1744
Parameters::Phase Control::Configure
0
0:SAME AS MOTOR FBK
1:MAIN SPD FEEDBACK
2:SYSTEM BOARD SLOT 1
3:SYSTEM BOARD SLOT 2
STOPPED
Specifies the encoder to be used as the Slave input. Normally this will be the same as the speed feedback.
SAME AS MOTOT FBK : the Slave encoder is the encoder used as the motor feedback.
MAIN SPEED FEEDBACK : corresponds to the I/O feedback option
SYSTEM BOARD SLOT 1 : corresponds to the Slot 1 of the system board option
SYSTEM BOARD SLOT 2 : corresponds to the Slot 2 of the system board option
By default, the value
SAME AS MOTOT FBK
is selected.
If the Slave and the Motor Feedback are the same encoder, use
SAME AS MOTOT FBK
, otherwise, an error 301 or 302 or 303 will
occur : Motor speed feedback and position feedback ( slave ) cannot be the same.
Setup Successful
1749
Parameters::Phase Control::Configure
NEVER
The configuration of the master, slave and Speed loop encoders is correct
Summary of Contents for AC30 series
