Parker AC30 series, User Manual

Page: 190 / 522

12-25
Ethernet
AC30 series Variable Speed Inverters
PEER TO PEER PARAMETER SUMMARY
Note: The value of the Peer to Peer configuration parameters only become active when the Peer to Peer module initialises, i.e. on inverter power-
up or transition of the parameter 1725 Peer to Peer Enable to TRUE.
Parameter Name No. Path Default Range Units Writable
Peer to Peer Enable 1725 Setup::Communications::Peer to Peer
Parameters::Base Comms::Peer to Peer FALSE FALSE
TRUE
ALWAYS
Peer to Peer Parameter.
Enables the Peer to Peer module.
Destination IP Address 1726 Setup::Communications::Peer to Peer
Parameters::Base Comms::Peer to Peer 255.255.255.255 0.0.0.0 to
255.255.255.255
ALWAYS
Peer to Peer Parameter.
Sets the destination IP address of the data when the Peer to Peer module is sending. If the Destination IP Address is set to 255.255.255.255 then
the sent data is broadcast and all listening inverters will receive the data.
Destination Port 1727 Setup::Communications::Peer to Peer
Parameters::Base Comms::Peer to Peer 1250 1 to
65535
ALWAYS
Peer to Peer Parameter.
Sets the UDP port number the Peer to Peer module sends data to. Normally this will be set the same as the Local Port.
Local Port 1728 Setup::Communications::Peer to Peer
Parameters::Base Comms::Peer to Peer 1250 1 to
65535
ALWAYS
Peer to Peer Parameter.
Sets the UDP port number the Peer to Peer module receives the data on. Normally this will be set the same as the Destination Port.
Peer to Peer State
1729 Monitor::Communications::Peer to Peer
Parameters::Base Comms::Peer to Peer DISABLED DISABLED
ACTIVE
ERROR
NEVER
Peer to Peer Parameter.
A diagnostic parameter indicating the state of the Peer to Peer module.
Enumerated values:
0: DISABLED - the Peer to Peer module is disabled.
1: ACTIVE - the Peer to Peer module is enabled and ready for communications.
2: ERROR - the Peer to Peer module is in an error state and communications could not be established.