Parker AC30 series, User Manual

Page: 131 / 522

Setup Wizard
9-6
AC30 series Variable Speed Inverter
PNO Parameter
Validity
Comment
IM
VHz
IM
VECT PMAC AFE
0479 PMAC SVC Start Speed ● The speed setpoint at which the speed control is switched from an
open loop mode to a closed loop mode during the startup procedure
0464 100% Speed in RPM ● ● ● This is the speed in rpm at which the motor will turn when given a
speed demand of 100%.
0486 Acceleration Time ● ● ● The time that the inverter will take to ramp the setpoint from 0.00% to
100.00% when Ramp Type is LINEAR.
0487 Deceleration Time ● ● ● The time that the inverter will take to ramp the setpoint from 100.00%
to 0.00% when Ramp Type is LINEAR.
1257 Seq Stop Method VHz ● Selects stopping mode that the controller will use once the run
command has been removed when in Volts/Hertz control mode,
(induction motor only).
0484 Seq Stop Method SVC ● ● Selects stopping mode that the controller will use once the run
command has been removed when in Sensorless Vector or Closed
Loop Vector control mode.
0422 VHz Shape ● Selects the Volts to Frequency curve.
0390 Duty Selection ● ● ● Selects the inverter rating. Affects the ratio of nominal current
compared with maximum overload current.
1730 AFE Inductance ● Total inductance (3% + 5%) in the AFE configuration.
1711 AFE VDC Demand ● DC Link level demand in voltage control mode.
1693 AFE Current Control ● Sets AFE in current control mode.
1705 AFE Iq Demand ● Reactive power current demand.
1704 AFE Id Demand ● Active power current demand.
Fieldbus Options
This section is only shown if a communications option is fitted.
PNO Parameter Comment
0044 Comms Required This defaults to match the communications option that is fitted. If no option is required select NONE. Selecting
a different option will result in a configuration error.
These parameters are shown when the CANopen option is fitted.
PNO Parameter Comment
0044 Comms Required CANOPEN Refer to CANopen Technical Manual HA501841U001
0212 CANopen Node Address ●
0213 CANopen Baud Rate ●
0048 Comms Trip Enable ●