8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud
Management
Configure Routing
User Manual
256
Manually add an entry to the ARP table
You can manually add an entry to the ARP table.
To manually add an entry to the ARP table:
1.
Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2.
Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Access the switch on-network and
connected to the Internet on page
Access the switch off-network on page
The login page displays.
If the NETGEAR Business page displays, see
Register and access the switch with your
.
4.
Enter one of the following passwords:
•
After registration, enter the local device password.
By default, the local device password is
password
.
Port
The associated interface of the connection.
MAC Address
The unicast MAC address of the device. The address is six two-digit hexadecimal
numbers separated by colons, for example, 00:06:29:32:81:40.
Routing VLANs ARP Cache
IP Address
The IP address. This must be the IP address of a device on a subnet attached to
one of the switch’s existing routing interfaces.
Interface
The routing interface associated with the ARP entry.
MAC Address
The unicast MAC address of the device. The address is six two-digit hexadecimal
numbers separated by colons, for example 00:06:29:32:81:40.
Type
The type of ARP entry:
• Local
. An ARP entry associated with one of the switch’s routing interface’s
MAC addresses.
• Gateway
. A dynamic ARP entry for which the IP address is that of a router.
• Static
. An ARP entry that was configured manually.
• Dynamic
. An ARP entry that was learned by the switch.
Age
The time in seconds since the entry was last refreshed in the ARP cache.
Table 54. ARP cache information (continued)
Field
Description