8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
Cloud
Management
Get Started
User Manual
44
PoE Max LED in the Device View
For models GS110TPv3 and GS110TPP, the PoE Max LED indicates the following status:
•
Off
. Sufficient (more than 7W of) PoE power is available.
•
Solid yellow
. Less than 7W of PoE power is available.
Note:
The physical PoE Max LEDs on the switch can also blink yellow,
indicating that at least once during the previous two minutes, less than
7W of PoE power was available.
Configure interface settings
The switch supports physical and logical interfaces. Interfaces are identified by their type and
the interface number. The physical ports are Gigabit interfaces and are numbered on the
front panel. You configure the logical interfaces by using the software.
The following table describes the naming convention for all interfaces available on the switch.
Table 7. Naming conventions for interfaces
Interface
Description
Example
Physical
The physical ports are Gigabit Ethernet interfaces and are
numbered sequentially starting from 1.
g1, g2, g12
Link aggregation group (LAG)
LAG interfaces are logical interfaces that are used only for
bridging functions.
l1, l2, l3
CPU management interface
This is the internal switch interface responsible for the switch
base MAC address. The interface is not configurable and is
always listed in the MAC Address Table.
c1
For some features that allow you to configure interface settings, you can apply the same
settings simultaneously to any of the following:
•
A single port
•
Multiple ports
•
All ports
•
A single LAG
•
Multiple LAGs
•
All LAGs
•
Multiple ports and LAGs
•
All ports and LAGs