Fuji Xerox Phaser 5500, Service Manual

Page: 376 / 623

5-30 Phaser 5500 Printer Service Manual
Unfused Image
The printed image is not fully fused to the paper. The image rubs off easily.
Initial Actions
■
Check to ensure that the printer installation meets environmental
specifications. A location that’s too cold or too humid reduces fusing
performance.
■
Inspect the paper path for items, such as staples, paper clips, and paper
scraps.
■
Check to ensure that the paper is dry and within specifications.
■
Verify that the paper type is set correctly for the Fuser temperature
configuration.
3 Check the Drum Cartridge.
1. Install a new Drum Cartridge.
2. Print a Test Print.
Is the image density normal?
Problem solved. Go to Step 4.
4 Check the Transfer Roller.
1. Remove the Transfer Roller.
2. Check for contamination or wear.
Is there contamination or wear?
Go to Step 5. Replace the Transfer
Roller (page 8-44).
5 Check the Heat and Pressure Roller.
WARNING: Allow the Fuser to cool
before removing it.
Remove the Fuser.
Is there contamination or defects
on Heat or Pressure Roller?
Replace the Fuser
(page 8-76). Go to Step 6.
6 Replace the Engine Logic Board
(page 8-89).
Print a Test Print.
Is the Test Print normal? Problem solved. Replace the I/P Board
(page 8-91).
Spots Troubleshooting Procedure (Continued)
Step Actions and Questions Yes No