Fuji Xerox Phaser 5500, Service Manual

Page: 153 / 623

Error Messages, Codes, and Procedures 3-75
7 Check for +5 V to the Registration Sensor.
Is there +5 V across P403-13 <=>
P403-3 on the Engine Logic Board?
Go to Step 8. Replace the
Engine Logic
Board
(page 8-89).
8 Check the Registration Sensor.
Does the voltage across P403-8 <=>
P403-3 on the Engine Logic Board
change when the sensor actuator is
operated? Go to Step 16. Replace the
Registration
Sensor
(page 8-52).
9
Test the Tray 6 Take Away Motor.
Run the Service Diagnostics Tray 6 Take
Away Motor high speed test.
Does the motor rotate normally? Go to Step 16. Go to Step 10.
10 Check the Main Harness connections.
Are PF57 and P/JF06 connected? Go to Step 12. Connect and go
to Step 11.
11 Print a Test Print.
Does the error still occur? Go to Step 12. Problem solved.
12 Check the Main Harness continuity.
1. Disconnect PF57 and JF06.
2. Check for continuity at the following:
PF57-7 <=> P/JF06-11
PF57-6 <=> P/JF06-8
PF57-5 <=> P/JF06-9
PF57-4 <=> P/JF06-10
PF57-3 <=> P/JF06-12
PF57-2 <=> P/JF06-7
Are these conductive?
Go to Step 13. Repair Main
Harness.
13 Check the Take Away Motor resistance.
Are the resistances across JF57-3/
4(COM) and JF57-1/2/5/6, XXXX ohm? Go to Step 14. Replace the Take
Away Motor
(page 3-64).
14
Check for +24 V to the Take Away Motor.
Is there +24 V across PF06-9 <=> PF04-
2, and PF06-10 <=> PF04-2 on the Tray 6
PWB? Go to Step 15. Replace the Tray
6 PWB
(page 3-67).
15 Replace the Take Away Motor.
Print a Test Print.
Does the error still occur? Go to Step 16. Problem solved.
16 Replace the Tray 6 PWB.
Print a Test Print.
Does the error still occur? Replace the
Engine Logic
Board
(page 8-89). Problem solved.
Jam at B (Registration Sensor) Troubleshooting Procedure (Continued)
Step Actions and Questions Yes No