Fuji Xerox Phaser 5500, Service Manual

Page: 125 / 623

Error Messages, Codes, and Procedures 3-47
Jam at E - E4-6 Exit 2 Area Jam
Paper remains at the Exit 2 Exit Sensor located behind Door E.
Applicable Error Codes
Jam at E - E4-6 Exit 2 Area Jam
20 Test the Exit 2 Motor operation.
Run the Service Diagnostics Exit 2 Output
Motor tests.
Does the Exit 2 Motor operate properly? Replace the
Engine Logic
Board
(page 8-89). Go to Step 21.
21 Check the Exit 2 Motor connection.
Are P/J208, P/J606A and P/J433
connected? Go to Step 22. Connect P/J208,
P/J606A and
P/J433.
22 Check continuity between the Exit 2 Motor
and Exit PWB.
Is there continuity on each wire
between P/J208 <=> P/J433? Go to Step 23. Repair the wiring.
23 Check for +24 V to the Exit 2 Motor.
Is there +24 V across P208-5 (+) <=>
ground? Replace the Exit 2
Motor
(page 3-104). Go to Step 24.
24
Check the connection between the Exit
PWB and Engine Logic Board.
Are P/J431 and P/J421 connected? Go to Step 25. Connect P/J431
and P/J421.
25 Check continuity between the Exit PWB
and Engine Logic Board.
Is there continuity on each wire
between P/J431 <=> P/J421? Go to Step 26. Repair the wiring.
26 Check the connection between the Exit
PWB and the LVPS.
Are P/J430 and P/J526 connected? Go to Step 27. Connect P/J430
and P/J526.
27 Check continuity between the Exit PWB
and the LVPS.
Is there continuity on each wire
between P/J430 <=> P/J526? Go to Step 28. Repair the wiring.
28 Check for +24 V to the Exit PWB.
Is there +24 V across P/J430-1 (+) <=>
ground? Replace the Exit
PWB (page 8-88). Replace the
LVPS
(page 8-92).
E4-3 Exit 2 Area Jam Troubleshooting Procedure (Continued)
Step Actions and Questions Yes No