Fuji Xerox Phaser 5500, Service Manual

Page: 228 / 623

3-150 Phaser 5500 Printer Service Manual
Exit Unit Failure - H3-n Offset Error
Failure to establish Offset Home Position on Exit1 (H3-1) or Exit 2 (H3-2).
Applicable Error Codes
Exit Unit Failure - H3-1 Offset Error
Exit Unit Failure - H3-2 Offset Error
2 Check for +24 V to the Duplex PWB.
Is there +24 V across P/J540-2 (+) <=>
ground? Replace the
Duplex PWB
(page 3-77). Replace the
Engine Logic
Board
(page 8-89).
Exit Offset Error (OCT Position Sensor) Troubleshooting Reference
Applicable Parts References
■
OCT Position
Sensor
■
Offset Motor
■
Exit PWB
■
LVPS
■
Engine Logic
Board
■
Print Engine P/J Engine Logic Board (page 10-13)
■
Print Engine P/J Laser and Exit PWB (page 10-7)
■
Print Engine LVPS Wiring (page 10-21)
■
Print Engine Exit 1 Wiring (page 10-30)
■
PL8.1 Print Engine Electrical (page 9-40)
■
Phaser 5500 Printer Options Service Manual
■
Exit 2 Plug/Jack Locator (page 5-15)
■
Exit 2 General Wiring (page 5-7)
■
PL24.2 Exit 2 Tray Guide Assembly (page 4-40)
Exit Offset Error (OCT Position Sensor) Troubleshooting Procedure
Step Actions and Questions Yes No
1
Test the affected OCT Position Sensor.
Run the Service Diagnostics Exit 1 or 2
Offset Home Position Sensor test.
Does the sensor state change? Go to Step 10. Go to Step 2.
2
Check the sensor connection.
Is P/J117 (Exit 1) or P/J111 (Exit 2)
connected? Go to Step 3. Connect the
sensor.
3
Check continuity between the affected
OCT Position Sensor and the Exit PWB P/
J111 <=> P/J434 and SJ1 (Exit2) P/J117
<=> P/J423 (Exit 1).
Is there continuity on each wire? Go to Step 4. Repair the wiring.
Incorrect Duplex Unit Installed Troubleshooting Procedure (Continued)
Step Actions and Questions Yes No