Fuji Xerox Phaser 5500, Service Manual

Page: 121 / 623

Error Messages, Codes, and Procedures 3-43
8 Check for +5 V at the Fuser Exit Sensor.
Is there +5 V across the sensor
connector’s P/J125-3 <=> ground? Replace the Fuser
Exit Sensor
(page 8-77). Replace the
Engine Logic
Board
(page 8-89).
9 Test the Exit 1 Motor operation.
Run the Service Diagnostics Exit 1 Motor
tests.
Does the motor operate properly? Go to Step 18. Go to Step 10.
10 Check the Exit 1 Motor connection.
Are P/J206 and P/J432 connected? Go to Step 11. Connect P/J206
and P/J432.
11 Check continuity between the Exit 2 Motor
and Engine Logic Board.
Is there continuity on each wire
between P/J206 <=> P/J432? Go to Step 12. Repair the wiring.
12
Check for +24 V to the Exit 1 Motor.
Is there +24 V across P206-5 (+) <=>
ground? Replace the Exit 1
Offset Motor
(page 8-80). Go to Step 13.
13 Check the connection between the Exit
PWB and Engine Logic Board,
Are P/J431 and P/J421 connected? Go to Step 14. Connect P/J431
and P/J421.
14 Check continuity between the Exit PWB
and the Engine Logic Board.
Is there continuity on each wire
between P/J431 <=> P/J421? Go to Step 15. Repair the wiring.
15 Check the connection between the Exit
PWB and the LVPS.
Are P/J430 and P/J526 connected? Go to Step 16. Connect P/J430
and P/J526.
16
Check continuity between the Exit PWB
and the LVPS.
Is there continuity on each wire
between P/J430 <=> P/J526? Go to Step 17. Repair the wiring.
17 Check for +24 V to the Exit PWB.
Is there +24 V across P/J430-1 (+) <=>
ground? Replace the Exit
PWB (page 8-88). Replace the
LVPS
(page 8-92).
18 Test the Exit 2 Exit Sensor.
1. Open Door E.
2. Run the Service Diagnostics Exit Sensor
test.
Does the sensor change state?
Replace the
Engine Logic
Board
(page 8-89). Go to Step 19.
19 Check the Exit 2 Exit Sensor connection.
Are P/J112, P/J606B, and P/J434
connected? Go to Step 20. Connect the
sensor.
E4-1 Exit 2 Area Jam Troubleshooting Procedure (Continued)
Step Actions and Questions Yes No