Fuji Xerox Phaser 5500, Service Manual

Page: 258 / 623

3-180 Phaser 5500 Printer Service Manual
7 Check the Set Clamp Home Sensor signal.
Does the voltage across P8302B-11<=>
P8302B-9 on the Finisher Main PWB
change when the sensor is blocked? Replace the
Finisher Main
PWB
(page 3-248). Replace the Set
Clamp Home
Sensor
(page 3-188).
8 Test the Eject Motor.
Run the Service Diagnostics Low Speed
Forward and Reverse Eject Motor tests.
Does the Eject Motor rotate normally? Go to Step 15. Go to Step 9.
9 Check Eject Motor Harness connections.
Are P/J8336 and P/J8304 connected? Go to Step 11. Connect and go
to Step 10.
10 Print a Test Print.
Does the error still occur? Go to Step 11. Problem solved.
11 Check Eject Motor Harness continuity.
1. Disconnect P/J8336 and P/J8304.
2. Check for continuity at the following:
P/J8336-1 <=> P/J8304-15
P/J8336-2 <=> P/J8304-12
P/J8336-3 <=> P/J8304-17
P/J8336-4 <=> P/J8304-19
P/J8336-5 <=> P/J8304-14
P/J8336-6 <=> P/J8304-21
Are these conductive?
Go to Step 12. Repair the Eject
Motor Harness.
12 Check Eject Motor resistance.
Is there resistance across P8336-2/
5(COM) and P8336-1/3/4/6? Go to Step 13. Replace the Eject
Bracket Assembly
(page 3-187).
13 Check for +24 V to the Eject Motor.
Is there +24 V across J8304-12 <=>
ground, and J8304-14 <=> ground on
the Finisher Main PWB? Go to Step 14. Replace the
Finisher Main
PWB
(page 3-248).
14 Replace the Eject Clamp Motor.
Print a Test Print.
Does the error still occur? Replace the
Finisher Main
PWB
(page 3-248). Problem solved.
15 Test the Set Clamp Clutch (Clutch Z34).
Run the Service Diagnostics Set Clamp
Clutch test.
Does the Set Clamp Clutch operate? Replace the
Finisher Main
PWB
(page 3-248). Go to Step 16.
16 Check the Set Clamp Clutch Harness
connection.
Are P/J8338B and P/J8304 connected? Go to Step 18. Connect and go
to Step 17.
17
Print a test Print.
Does the error still occur? Go to Step 18. Problem solved.
Eject Clamp (Set Clamp Home Sensor) Troubleshooting Procedure (Continued)
Step Actions and Questions Yes No