Fuji Xerox Phaser 5500, Service Manual

Page: 134 / 623

3-56 Phaser 5500 Printer Service Manual
Jam at Tray n - Pre-Feed
Paper fed from a universal tray did not reach the Pre-Feed Sensor, located on the
tray’s Feeder, on time.
Applicable Error Codes
Jam at Tray 2 - C1-2 Tray 2
Jam at Tray 3 - C2-1 Tray 3
Jam at Tray 4 - C3-0 Tray 4
Jam at Tray 5 - C4-4 Tray 5
21 Check Registration Sensor operation.
Run the Service Diagnostics Registration
Sensor test.
Does the sensor status change? Replace the
Engine Logic
Board
(page 8-89). Go to Step 22.
22 Check the Registration Sensor connection.
Are P/J104 and P/J403 connected? Go to Step 23. Connect P/J104
and P/J403B.
23 Check continuity between the Registration
Sensor and Engine Logic Board.
Is there continuity on each wire
between P/J104 <=> P/J403? Go to Step 24. Repair the wiring.
24 Check for +5 V to the Registration Sensor.
Is there +5 V across P/J104-1 (+) <=>
ground? Replace the
Registration
Sensor
(page 8-52). Go to Step 25.
25 Check continuity between the Duplex PWB
and Engine Logic Board.
Is there continuity on each wire
between P/J540 <=> P/J417? Go to Step 26. Repair the wiring.
26 Check for +5 V to the Duplex PWB.
Is there +5 V across P/J540-1 (+) <=>
ground? Replace the
Duplex PWB
(page 3-77). Replace the
Engine Logic
Board
(page 8-89).
C6-2 Duplex Area Jam Troubleshooting Procedure (Continued)
Step Actions and Questions Yes No