Fuji Xerox Phaser 5500, Service Manual

Page: 154 / 623

3-76 Phaser 5500 Printer Service Manual
Jam at B - C8-2 F/O3 SNR Static Jam
Paper remains at Feed Out Sensor #3 located behind Door B.
Applicable Error Code
Jam at B - C8-2 F/O3 SNR Static Jam
Jam at B (Feed Out #3 Sensor) Troubleshooting Reference
Applicable Parts References
■
Feed Out Sensor #3
■
Tray 3 Feed/Lift Motor
■
Engine Logic Board
■
Print Engine P/J Tray 2 & 3 Feeder (page 10-11)
■
Print Engine Registration Transport Wiring
(page 10-23)
■
PL2.3 Feeder (2/2) (page 9-12)
■
PL4.5 Registration (page 9-30)
■
PL8.1 Print Engine Electrical (page 9-40)
Jam at B (Feed Out #3 Sensor) Troubleshooting Procedure
Step Actions and Questions Yes No
1 Check the paper path.
Open Door B.
Does the paper touch the Tray 3 Feed
Out Sensor? Remove the
paper. Go to Step 2.
2 Test the Feed Out Sensor #3.
1. Open Door B.
2. Run the Service Diagnostics Tray 3
Feed Out Sensor test.
Does the sensor change state?
Replace the
Engine Logic
Board (8-89). Go to Step 3.
3 Check the sensor connection.
Are P/J105, P/J608, and P/J410
connected? Go to Step 4. Connect the
sensor.
4 Check continuity between the sensor and
Engine Logic Board.
Is there continuity on each wire
between P/J105 <=> P/J410? Go to Step 5. Repair the wiring.
5 Check for +5 V to the Feed Out Sensor #3.
Is there +5 V across P105-1(+)<=>
ground? Replace the Feed
Out Sensor #3
(page 8-54). Replace the
Engine Logic
Board
(page 8-89).