Fuji Xerox Phaser 5500, Service Manual

Page: 127 / 623

Error Messages, Codes, and Procedures 3-49
Jam at E - E8-2 Duplex Area Jam
Paper being fed into the Duplex Unit did not reach the Wait Sensor on time.
Applicable Error Codes
Jam at E - E8-2 Duplex Area Jam
9 Check continuity between the Exit PWB
and LVPS.
Is there continuity on each wire
between P/J430 <=> P/J526? Go to Step 10. Repair the wiring.
10 Check for +24 V to the Exit PWB.
Is there +24 V across P/J430-1 (+) <=>
ground? Replace the Exit
PWB (page 8-88). Replace the
LVPS
(page 8-92).
E8-2 Duplex Area Jam Troubleshooting Reference
Applicable Parts References
■
Duplex Wait Sensor
■
Exit 2 Motor
■
Exit 2 OCT Roller
■
Exit 2 FU Roller
■
Exit 2 Inv Roller
■
Exit PWB
■
Duplex Unit PWB
■
Engine Logic Board
■
LVPS
■
Print Engine P/J Engine Logic Board (page 10-13)
■
Print Engine Exit 1 Wiring (page 10-30)
■
PL8.1 Print Engine Electrical (page 9-40)
■
Phaser 5500 Printer Options Service Manual
■
Exit 2 Plug/Jack Locator (page 5-15)
■
Exit 2 General Wiring (page 5-7)
■
Duplex Unit Plug/Jack Locator (page 5-12)
■
Duplex Unit Wiring (page 5-13)
■
PL23.1 Duplex Unit (page 4-34)
■
PL24.1 Exit 2 L/H Upper Chute (page 4-38)
■
PL24.2 Exit 2 Tray Guide Assembly (page 4-40)
E8-2 Duplex Area Jam Troubleshooting Procedure
Step Actions and Questions Yes No
1 Check paper position at Door E.
Does paper remain in Exit 2? Remove the
paper. Go to Step 2.
2 Check the FU Roller.
Is the FU Roller worn or contaminated
with paper dust? Clean or replace
the FU Roller. Go to Step 3.
3
Check the drive transmission.
Does the FU Roller and gears rotate
smoothly? Go to Step 4. Restore proper
operation.
E4-6 Exit 2 Area Jam Troubleshooting Procedure (Continued)
Step Actions and Questions Yes No