Fuji Xerox Phaser 5500, Service Manual

Page: 122 / 623

3-44 Phaser 5500 Printer Service Manual
Jam at E - E4-3 Exit 2 Area Jam
Paper did not pass the Exit 2 Exit Sensor located behind Door E on time.
Applicable Error Codes
Jam at E - E4-3 Exit 2 Area Jam
Jam at A - E4-5 Exit 2 Area Jam
20 Check continuity between the Exit 2 Exit
Sensor and Exit PWB.
Is there continuity on each wire
between P/J112 <=> P/J434? Go to Step 21. Repair the wiring.
21 Check for +5 V at the Exit 2 Exit Sensor.
Is there +5 V across the sensor
connector’s P/J112-3 <=> ground? Replace the Exit
Sensor
(page 3-102). Go to Step 22.
22 Check the connection between the Exit
PWB and Engine Logic Board.
Are P/J431 and P/J421 connected? Go to Step 23. Connect P/J431
and P/J421.
23 Check continuity between the Exit PWB
and Engine Logic Board.
Is there continuity on each wire
between P/J431 <=> P/J421? Go to Step 24. Repair the wiring.
24 Check the connection between the Exit
PWB and the LVPS.
Are P/J430 and P/J526 connected? Go to Step 25. Connect P/J430
and P/J526.
25 Check continuity between the Exit PWB
and the LVPS.
Is there continuity on each wire
between P/J430 <=> P/J526? Go to Step 26. Repair the wiring.
26 Check for +24 V to the Exit PWB.
Is there +24 V across P/J430-1 (+) <=>
ground? Replace the Exit
PWB (page 8-88). Replace the
LVPS
(page 8-92).
E4-1 Exit 2 Area Jam Troubleshooting Procedure (Continued)
Step Actions and Questions Yes No