Fuji Xerox Phaser 5500, Service Manual

Page: 238 / 623

3-160 Phaser 5500 Printer Service Manual
Stacker Lower Tray Failure - H5-11 Low Tray Fail
The Lower Tray No Paper Sensor is not turned Off or On within the specified time
following the Stacker Tray beginning to move.
Applicable Error Code
Stacker Lower Tray Failure - H5-11 Low Tray Fail
4 Check continuity between the Finisher
Main PWB and the Engine Logic Board.
1. Disconnect P/J8300 and P/J416.
2. Check for continuity at the following:
P/J8300-11 <=> P/J416-1
P/J8300-10 <=> P/J416-2
P/J8300-9 <=> P/J416-3
P/J8300-8 <=> P/J416-4
P/J8300-7 <=> P/J416-5
P/J8300-6 <=> P/J416-6
P/J8300-4 <=> P/J416-7
P/J8300-3 <=> P/J416-8
P/J8300-2 <=> P/J416-9
P/J8300-1 <=> P/J416-10
P/J8300-4 <=> P/J416-11
Are these conductive?
Go to Step 4. Repair the wiring.
5
Check for +24 V to the Finisher Main PWB.
Is there +24 V across J416-6 (+) <=>
ground? Replace the
Finisher Main
PWB
(page 3-248). Replace the
Engine Logic
Board
(page 8-89).
Stacker Lower Tray Failure (Stack Height Sensors) Troubleshooting Reference
Applicable Parts References
■
Lower Tray No Paper
Sensor
■
Upper Limit Actuator
■
Finisher Main PWB
■
Main Sensor Harness
■
Elevator Motor
■
Engine Logic Board
■
Print Engine P/J Engine Logic Board (page 10-13)
■
PL8.1 Print Engine Electrical (page 9-40)
■
Phaser 5500 Printer Options Service Manual
■
Finisher Main PWB P/J Locator (page 5-35)
■
Finisher Sensors (2/2) Wiring (page 5-41)
■
Finisher Clutch and Solenoids (page 5-43)
■
PL25.6 Finisher Stack (page 4-54)
■
PL25.14 Finisher Electrical (page 4-70)
■
PL25.15 Finisher Harness (page 4-72)
Finisher Board Error (NVRAM R/W Error) Troubleshooting Procedure (Continued)
Step Actions and Questions Yes No