Fuji Xerox Phaser 5500, Service Manual

Page: 17 / 623

Safety xv
Power Safety Precautions
Power Source
For 110 VAC printers, do not apply more than 135 volts RMS between the supply
conductors or between either supply conductor and ground. For 220 VAC printers, do
not apply more than 254 volts RMS between the supply conductors or between either
supply conductor and ground. Use only the specified power cord. This manual
assumes that the reader is a Xerox-certified service technician.
Plug the three-wire power cord (with grounding prong) into a grounded AC outlet
only. If necessary, contact a licensed electrician to install a properly grounded outlet.
If the product loses its ground connection, contact with conductive parts may cause an
electrical shock.
Disconnecting Power
Turning the power off using the On/Off switch does not completely de-energize the
printer. You must also disconnect the printer power cord from the AC outlet. Position
the power cord so that it is easily accessible during servicing so that you may power
down the printer during an emergency.
■ Disconnect the power plug by pulling the plug, not the cord.
■
Disconnect the power cord in the following cases:
■
if the power cord or plug is frayed or otherwise damaged,
■
if any liquid or foreign material is spilled into the case,
■
if the printer is exposed to any excess moisture,
■
if the printer is dropped or damaged,
■
if you suspect that the product needs servicing or repair,
■
whenever you clean the product.