Fuji Xerox Phaser 5500, Service Manual

Page: 119 / 623

Error Messages, Codes, and Procedures 3-41
Jam at A - E3-6 Fuser Area Jam
Paper remains at the Fuser Exit Sensor located behind Door A.
Applicable Error Code
Jam at A - E3-6 Fuser Area Jam
E3-6 Fuser Area Jam Troubleshooting Reference
Applicable Parts References
■
Fuser Exit
Sensor
■
Engine Logic
Board
■
Print Engine P/J Drum and Toner Cartridge (page 10-6)
■
Print Engine Fuser Wiring (page 10-22)
■
PL6.1 Fuser and Exit 1 (page 9-34)
■
PL8.1 Print Engine Electrical (page 9-40)
E3-6 Fuser Area Jam Troubleshooting Procedure
Step Actions and Questions Yes No
1 Check paper position at Door A.
Is paper touching the Fuser Exit
Sensor? Remove the
paper. Go to Step 2.
2
Test the Fuser Exit Sensor.
1. Open Door A.
2. Run the Service Diagnostics Fuser Exit
Sensor test.
Does the sensor change state?
Replace the
Engine Logic
Board
(page 8-89). Go to Step 3.
3
Check the Fuser Exit Sensor connection.
Are P/J125 and P/J410 connected? Go to Step 4. Connect the
sensor.
4 Check continuity between the Fuser Exit
Sensor and Engine Logic Board.
Is there continuity on each wire
between P/J125 <=> P/J410? Go to Step 5. Repair the wiring.
5 Check for +5 V at the Fuser Exit Sensor.
Is there +5 V across the sensor
connector’s P/J125-3 <=> ground? Replace the Fuser
Exit Sensor
(page 8-77). Replace the
Engine Logic
Board
(page 8-89).