Fuji Xerox ApeosPort-V C5580, Administrator'S Manual

Page: 480 / 797

15 Problem Solving
480
Pro
b
lem
So
lv
in
g
15
003-702 [Cause] You tried to copy sides 1 and 2 of a document simultaneously specifying different
Reduce/Enlarge ratio for each side.
[Remedy] Specify the same Reduce/Enlarge ratio for both sides.
003-703 [Cause] The Calibration Chart is not detected correctly.
[Remedy] Place the Calibration Chart properly.
003-704
[Cause] An error is found in the calibration pattern read, and the machine may be out of order.
[Remedy] Execute the calibration again. If the error is not still resolved, contact our Customer
Support Center.
003-705 [Cause] Copying is started before the machine exits the Power Saver mode and detects the
change for the tray size, when the paper size set in the tray that has been changed
during the Power Saver mode.
[Remedy] Cancel copying, and perform the operation for copying again.
003-750
[Cause] Unable to store any documents using the 2 Sided Book Copying feature.
[Remedy] Check the 2 Sided Book Copying settings.
Refer to "3 Copy" > "Layout Adjustment" in the User Guide.
003-751 [Cause] Unable to process the document because the specified scan area is too small.
[Remedy] Increase the resolution or scan area.
003-752
[Cause] A mix sized document was to be scanned at 600 dpi in Color/2 sided.
[Remedy] Set [Resolution] to [400dpi] or lower, and try scanning again.
003-753 [Cause] A mix sized document was to be scanned at high resolution, 2 sided.
[Remedy] Set [Resolution] to [200dpi], and scan the document again.
003-754
003-755 [Cause] An error occurred in the document feeder.
[Remedy] Execute the job again.
003-756 [Cause] The faxed document is completely blank.
[Remedy] Check whether the document is blank or whether the side of the document to be faxed
is loaded correctly.
003-757 [Cause] A mix sized document was to be scanned at high resolution, 2 sided.
[Remedy] Set [Resolution] to [300dpi] or lower, and scan the document again.
003-760 [Cause] An incompatible combination of feature is specified for document scan conditions.
[Remedy] Confirm the selected options.
003-761 [Cause] The paper size of the tray selected for auto tray differs from the paper size of the tray
selected for Auto Paper selection.
[Remedy] Change the paper size for the tray, or change the [Paper Type Priority] settings.
003-763 [Cause] An error occurred when reading the Calibration Chart.
[Remedy] Place the Calibration Chart correctly on the document glass.
Refer to "Executing Calibration" (P.96).
003-780
[Cause] Failed to compress the scanned document.
[Remedy] Reduce the resolution or the ratio for [Reduce/Enlarge] to decrease the data size, or split
the data to send it separately.
Error Code Cause and Remedy