Fuji Xerox ApeosPort-V C5580, Administrator'S Manual

Page: 296 / 797

5 Tools
296
To
ols
5
F Code
Select whether or not to use F code communications.
F Code is the transmission procedure set by the Communications and Information Network
Association of Japan and is the T.30 (communication protocol) method for using sub-
addresses that are standardized by the ITU-T.
For F code (sub address) and password, you can use up to 20 digits 0 to 9, *, and #.
1
Select [On].
2
Enter the F code with the numeric keypad.
Note • The F code consists of “0” + folder number. For example, if the folder number is 123, the F code will
be “0123”.
3
Enter the password as required with the numeric keypad, and then select [Save].
Note • You can enter up to 20 digits for the password.
Relay Broadcast
Set the instruction given to a relay station, which is used when the machine is a base station
and the registered speed dial is a relay station for relay broadcast.
When selecting [On], set [Relay Station ID], [Print at Relay Station], and [Broadcast
Recipients].
1
Select [On].
2
Enter a 2-digit relay station ID with the
numeric keypad.
Note • The relay station ID is the address number
for the base station (the machine) already
registered on the relay station.
3
Select [Speed Dial 001<->099].
4
Enter a speed dial number of broadcast
destination (001 to 099) or group number (#01 to #09) registered on the relay station with
the numeric keypad, and then select [Add].
Note • If there are more than one broadcast destinations, repeat step 4.
5
To print a document also at the relay station, under select [On] for [Print at Relay Station].
6
Select [Save].
Billing - Day Time, Billing - Night Time, Billing - Midnight
Set the connection time for one unit charge in each of the time bands (daytime/night/
midnight).
You can set a value from 0.1 to 255.9 seconds in 0.1 second increments.
This item is displayed when [Accounting] > [Accounting Type] is set to [Local Accounting] and [Fax/Internet Fax Service] is
set to [Enable Accounting] under [Auditron Mode]. For information on how to enable the feature, refer to "Auditron Mode"
(P.304).
The information registered can be confirmed by printing a Billing Data List. For information about how to print, refer to
"Billing Data List" (P.114).
1
Select one of [Billing - Day Time], [Billing - Night Time], and [Billing - Midnight].
2
Select [Billing].
3
Enter the time for one unit charge from 0.1 to 255.9 seconds in 0.1 second increments with
the numeric keypad.