Fuji Xerox ApeosPort-V C5580, Administrator'S Manual

Page: 737 / 797

HP-GL/2 Emulation
737
A
ppe
n
d
ix
16
2) Because there are no font size specification commands and all pen widths are 0.1 mm in
the above example, add the height/2 of the default font size for A3 size paper (75
plotter units) to the active coordinates area obtained in step 1.
The active coordinates area obtained in step 2 is -8474,-6013,8474,6013.
3) The value set in paper margins (10 mm = 400 plotter units) is subtracted from the active
coordinates area obtained in step 2.
The active coordinates area obtained in step 3 is -8074,-5613,8074,5613.
4) As the active coordinates area obtained in step 3 exceeds the A4 size and is A3 size, the
document size is determined to be A3.
In addition, when the paper margin setting is 0 mm and the active coordinates area is
8474,-6013,8474,6013, and this exceeds A3, but is A2 or smaller, the document size is
determined to be A2.
How to Determine Paper Size
If the operation panel settings are as follows, the paper size is determined as below.
Document size: Auto
Paper Tray: Auto
The method for determining the paper size differs according to the paper size and scaling
mode settings on the operation panel.

If the Paper Size Setting is A Sizes
The paper sizes among the three sizes (A3, A4, and A5) that are actually loaded in the trays
become the possible paper size.
If A series paper (A3, A4, A5) is not loaded in the trays, all three sizes, A3, A4, and A5 become
possible sizes; a message is displayed on the touch screen prompting the user to load A series
paper.

If the Paper Size Setting is Auto
The paper sizes among the five sizes (A3, B4, A4, B5, and A5) that are actually loaded in the
trays become the possible paper size.
If A3, B4, A4, B5, or A5 paper is not loaded in the trays, all five sizes become possible sizes;
a message is displayed on the touch screen prompting the user to load paper.

If the Scaling Mode Setting is Paper Size
If the paper size and the document size are the same, select paper that is the same size as
the document.
If the document size is larger than any possible paper sizes, select the largest paper.
If the document size is smaller than any possible paper sizes, select the smallest paper.

If the Scaling Mode Setting is ACA
Select the smallest paper size that can contain the ACA.
If the active coordinates area is larger than any possible paper sizes, select the largest paper.
If the active coordinates area is smaller than any possible paper sizes, select the smallest
paper.
Note • If the document size is set to anything other than Auto, the paper size is the one set on the control
panel.
• If the paper tray is set to Auto, the paper size is the one loaded in each tray. However, If paper
whose size is not supported is loaded, an error message will be displayed prompting the user to load
a supported paper.