Burkert Flowave 8098, Operating Instructions Manual

Page: 255 / 354

255
Type 8098 FLOWave L
17 SAW SENSOR – MAINTENANCE .......................................................................................................257
17.1 User levels of the editable menu items ..................................................................................257
17.2 Default settings ........................................................................................................................257
17.3 Reading out some device information ....................................................................................257
17.3.1 Reading out the ordering codes of the device, the transmitter board and
the measurement board ..........................................................................................257
17.3.2 Reading out the serial numbers of the device, the transmitter board and
the measurement board ..........................................................................................258
17.3.3 Reading out the hardware and software versions of the transmitter board
and of the measurement board ...............................................................................258
17.3.4 Reading out the characteristics of the measurement tube ...................................258
17.3.5 Checking the correct operation of the sensor .......................................................259
17.3.6 Reading out the calibration date at the manufacturer ..........................................260
17.3.7 Reading out the liquid type and the liquid temperature during calibration
at the manufacturer ................................................................................................261
17.3.8 Reading out the raw measured value of the volume flow rate .............................261
17.4 Setting the direction of the flow ..............................................................................................262
17.5 Calibrating the offset value of the flow zero point ..................................................................262
17.6 Setting the offset value of the flow zero point ........................................................................263
17.7 Setting the K factor ..................................................................................................................264
17.8 Calibrating the K factor by using a teach-in procedure .........................................................264
17.8.1 Calibrating the K factor by using a teach-in procedure depending on the
volume flow rate ......................................................................................................265
17.8.2 Calibrating the K factor by using a teach-in procedure depending on a
known volume .........................................................................................................266
17.8.3 Calibrating the K factor by using a teach-in procedure depending on the
mass flow rate ..........................................................................................................267
17.8.4 Calibrating the K factor by using a teach-in procedure depending on a
known mass .............................................................................................................268
17.9 Resetting the flow rate calibration data to its default values .................................................270
17.10 Setting the offset value of the liquid temperature ..................................................................270
17.11 Calibrating the offset value of the liquid temperature ............................................................271
17.12 Resetting the offset of the liquid temperature to its default value ........................................272
17.13 Resetting all the calibration data to its default values (standard measurement values) ......272
17.14 Setting the offset value of the differentiation factor ...............................................................273
Menu
SAW sensor
–
MAINTENANCE
English