Burkert Flowave 8098, Operating Instructions Manual

Page: 113 / 354

113
General settings – Parameter
Type 8098 FLOWave L
→
Confirm to access the Parameter view.
→
büS
→
Advanced
→
Termination resistor
→
On
→
Save.
The internal termination resistor is activated.
12.6.4 Deactivating the device internal termination resistor
If the device is not installed at the end of büS or of a CANopen fieldbus, deactivate the device internal ter -
mination resistor.
Max. two 120
W
termination resistors can equip büS or a CANopen fieldbus.
To deactivate the device internal termination resistor, do the following:
→
Go to the
CONFIGURATION
view.
→
General settings
→
Confirm to access the Parameter view.
→
büS Advanced
→
Termination resistor Off
→
Save.
The internal 120 W termination resistor is deactivated.
12.6.5 Changing the address of the device connected to a CANopen
bus
The address of the device is used by büS or the CANopen fieldbus the device can be connected to.
• If the device is connected to büS, büS automatically addresses the device. By default, the address of the
device on büS is 30.
• If the device is connected to a CANopen fieldbus, the addresses are not set automatically.
→
Make sure that each participant, including the device, connected to the CANopen fieldbus has a specifc
address.
If the device is connected to a CANopen fieldbus and another participant connected to the fieldbus has the
same address, do the following to change the address of the device:
→
Go to the CONFIGURATION view.
English