Burkert Flowave 8098, Operating Instructions Manual

Page: 134 / 354

134
General settings – Diagnostics
Type 8098 FLOWave L
→
Go to the DIAGNOSTICS view.
→
büS status
→
CANopen status .
• If the CANopen status is
Operational
, the PDOs are sent to büS.
• If the CANopen status is Pre-Op (pre-operational), the PDOs are not sent on büS or on the CANopen
fieldbus and a message is generated in the message list. For example, the Pre-Op status is active if the
Bus mode is set to Standalone (see chapter 12.6.7 ).
→
Go back to the parent menu.
13.4 Configuration provider information
13.4.1 Reading out the current status of the configuration provider
Do the following:
→
Go to the
CONFIGURATION
view.
→
General settings
→
Confirm to access the Parameter view.
→
Go to the DIAGNOSTICS view.
→
Configuration provider
→
Status
→
Go back to the parent menu.
Table 23: Possible statuses of the configuration provider
Status Meaning
Provider start
The configuration provider is starting.
Wait for changes The configuration provider operates normally and is waiting for changes of a client
(module).
Initialization The configuration provider is initializing.
Wait for clients The configuration provider has initialized successfully and is waiting for clients
(modules).
Verify clients The configuration provider is checking if the clients (modules) are available, are
missing or have been replaced.
Retrigger clients
The configuration provider asks the clients (modules) to sign up again. Happens
when a new client has signed up.
Inactive The configuration provider is not active on the device.
Disabled The configuration provider is disabled because an error has occurred.
English