Burkert Flowave 8098, Operating Instructions Manual

Page: 306 / 354

306
Menu Parameter
Type 8098 FLOWave L
21 MENU PARAMETER
The Industrial communication parameters can be set with the
Installer
user level.
The section describes the menus related to the industrial communication module which is fitted on the
device.
21.1 Default settings and information on configuration files
You can find the default settings of the device and information on the configuration files in the Ethernet
industrial communication supplement for the Type 8098 FLOWave L at country.burkert.com .
→
Before making any change in the settings, use the Bürkert Communicator software to print a pdf file with
all the default settings of the device.
21.2 Industrial Protocol settings
21.2.1 Choosing the communication protocol
Do the following:
→
Go to the CONFIGURATION view.
→
Industrial communication
→
Confirm to access the Parameter view.
→
Protocol settings
→
Protocol
→
Choose the communication protocol.
→
Save.
The gateway address is changed.
21.2.2 Reading out the MAC address of the device
You can read out the MAC address of the device. But be aware that the device uses 3 MAC addresses:
− 1 for the device (which is marked on a specific label and which can be read out in the configuration
menu),
− 1 for port X1 of the Industrial communication gateway (MAC address of the device plus 1),
− 1 for port X2 of the Industrial communication gateway (MAC address of the device plus 2).
English