Burkert Flowave 8098, Operating Instructions Manual

Page: 173 / 354

173
SAW sensor – Parameter
Type 8098 FLOWave L
15.6 Setting the parameters of the liquid temperature
15.6.1 Giving a user defined name to the measured liquid
temperature
The name is used to identify the process value in the user defined views and in all the menus where the
process value is displayed (for example in the Outputs menu).
By default, the name associated to the measured liquid temperature is Temperature .
To add a user defined name to the default name, do the following:
→
Go to the CONFIGURATION view.
→
SAW sensor
→
Confirm to access the Parameter view.
→
Stand. meas. values
→
Temperature
→
Value name
.
→
Enter the name by selecting and confirming each character. The name can have up to 19
characters.
→
OK
→
Save the name.
The name is changed.
15.6.2 Activating the damping of the liquid temperature values and
choosing a predefined damping level
The damping makes it possible to damp the fluctuations of the measured values of the liquid temperature:
• on the display,
• on the outputs. The damping of the liquid temperature comes in addition to the damping set for each
analog output (see chapter 18.3.2 ).
The damping is not applied to the new measured value, if the 2 following conditions are met:
• a
Low , Medium or High damping level is active,
• and the variation between 2 values that are measured one after the other is higher than 20 °C.
The refresh time, set in chapter 15.16, has no effect on the damping of the measured values.
By default, the measured liquid temperature values are not damped.
→
As an alternative to the 3 predefined damping levels Low , Medium or High , you can set your own
damping parameters. See 15.6.3 .
English