Burkert Flowave 8098, Operating Instructions Manual

Page: 175 / 354

175
SAW sensor – Parameter
Type 8098 FLOWave L
15.6.3 Activating a user-defined damping of the liquid temperature
values
The damping makes it possible to damp the fluctuations of the measured values of the liquid temperature:
• on the display,
• on the outputs. The damping of the liquid temperature comes in addition to the damping set for each
analog output (see chapter 18.3.2 ).
By default, the measured liquid temperature values are not damped.
To damp the fluctuations of the measured values, you can:
→
either choose 1 of the 3 predefined damping levels: Low , Medium or High . See chapter 15.6.2 .
→
Or you can set your own damping parameters with the Special damping.
With the Special damping, you can set 2 parameters:
• a user-defined
Response time
in seconds,
• the Jump threshold , i.e. a user-defined temperature value. If 2 consecutive measured values vary for ±
the set temperature value, no damping is applied to the second measured value.
To set your own damping parameters of the measured liquid temperature values, do the following:
→
Go to the
CONFIGURATION
view.
→
SAW sensor
→
Confirm to access the
Parameter
view.
→
Stand. meas. values
→
Temperature
→
Damping The Current settings are displayed
→
Special
→
Set the value of the
Response time
→
Choose if the Jump threshold is enabled or disabled
→
If the Jump threshold is enabled, set the value.
→
The New settings are displayed Save.
The special damping of the liquid temperature values is active.
English