Burkert Flowave 8098, Operating Instructions Manual

Page: 239 / 354

239
SAW sensor – Parameter
Type 8098 FLOWave L
15.14.4 Enabling the diagnostics for special events occurring on the
electronics
By default, all the diagnostics related to the electronics are disabled.
To enable the diagnostics related to the electronics, do the following:
→
Go to the CONFIGURATION view.
→
SAW sensor
→
Confirm to access the Parameter view.
→
Diag events
→
Electronic
→
Choose the event
→
Choose whether the information related to the electronics event is a Failure , an Out of specification ,
a Maintenance required or a Normal state
→
Save.
The diagnostics on the electronics event is enabled.
→
To be informed that an event occurs, activate all the diagnostics on the device. See chapter 12.10 .
15.14.5 Disabling the diagnostics on a special event occurring on the
sensor
By default, all the diagnostics related to special events occurring on the sensor are disabled.
If a special event occurring on the sensor is enabled, do the following to disable the event:
→
Go to the CONFIGURATION view.
→
SAW sensor
→
Confirm to access the Parameter view.
→
Diag events
→
Sensor
→
Choose the special event
→
Choose None
→
Save.
The diagnostics on the special event is disabled.
English