Burkert Flowave 8098, Operating Instructions Manual

Page: 210 / 354

210
SAW sensor – Parameter
Type 8098 FLOWave L
15.11.3 Activating the monitoring of each mass totalizer value
A monitored value can be:
• in the normal operating range.
• in the warning range,
• in the error range.
You can set 4 limit values: 2 error limits and 2 warning limits.
→
To set the limit values, see chapter 15.11.5 Changing the error limits, the warning limits and the hys -
teresis of each mass totalizer.
Fig. 52 in 15.4.5 explains how the device reacts when the monitored value enters in another range (for
example, from the normal range into the warning range). The reaction time depends on the hysteresis value
and if the monitored value increases or decreases.
By default, the monitoring of the mass totalizers and the diagnostics are all disabled.
To activate the monitoring of each mass totalizer, do the following:
→
Go to the CONFIGURATION view.
→
SAW sensor
→
Confirm to access the Parameter view.
→
Stand. meas. values
→
Mass totalizer 1 or Mass totalizer 2
→
Limits
→
Active
→
Yes
→
Save.
The monitoring of the mass totalizer is active and the device status will change depending on the limits
that have been set.
→
You can configure the behaviour of an analogue output depending on the status of the device. See
chapter 18.3.3 .
→
You can configure a digital output to switch every time a specific event is generated. See chapter 18.5.1
Configuring a digital output as an on/off output .
→
To enable the monitoring, i.e. to be informed when the value of a mass totalizer is outside the normal
range, enable the diagnostics. See chapter 12.10 Activating the diagnostics function .
English