Burkert Flowave 8098, Operating Instructions Manual

Page: 177 / 354

177
SAW sensor – Parameter
Type 8098 FLOWave L
→
Confirm to access the Parameter view.
→
Stand. meas. values
→
Temperature
→
Limits
→
Active
→
Yes
.
→
Save.
The monitoring of the liquid temperature is active and the device status will change depending on the
limits that have been set.
→
You can configure the behaviour of an analogue output depending on the status of the device. See
chapter 18.3.3 .
→
You can configure a digital output to switch every time a specific event is generated. See chapter 18.5.1
Configuring a digital output as an on/off output .
→
To enable the monitoring, i.e. to be informed when the value of the liquid temperature is outside the
normal range, enable the diagnostics. See chapter 12.10 Activating the diagnostics function .
15.6.6 Deactivating the monitoring of the liquid temperature
By default, the liquid temperature values are not monitored. If the monitoring of the liquid temperature is
active, do the following to deactivate it:
→
Go to the
CONFIGURATION
view.
→
SAW sensor
→
Confirm to access the Parameter view.
→
Stand. meas. values Temperature
→
Limits
→
Active
→
No
→
Save.
The monitoring of the liquid temperature is inactive.
English