Burkert Flowave 8098, Operating Instructions Manual

Page: 119 / 354

119
General settings – Parameter
Type 8098 FLOWave L
→
Set the hours
→
Set the minutes The new date and time settings are displayed.
→
Choose the unit system for all the measurements Confirm.
→
Save the Quick start settings or go back to the parent menu without saving the new settings.
12.10 Activating the diagnostics function
WARNING
Risk of injury due to non-conforming adjustment.
Non-conforming adjustment could lead to injuries and damage the device and its surroundings.
▶
The operators in charge of adjustment must have read and understood the contents of the Operating
Instructions.
▶
In particular, observe the safety recommendations and intended use.
▶
The device/installation must only be adjusted by suitably trained staff.
By default, all the diagnostics events related to the process, the electronics or the sensor, the messages
related to the monitoring of the process values (e.g. the flow rate) and the messages related to problems on
the device and on büS are disabled.
To activate the diagnostics, do the following:
→
Activate the needed diagnostics events. See chapter 15.14 .
→
Activate the monitoring of the process variables that must be monitored. See chapter 15.4.5 ,
chapter 15.6.5, chapter 15.8.5, chapter 15.10.3, chapter 15.12.6, chapter 15.13.7.
→
Go to the CONFIGURATION view.
→
General settings
→
Confirm to access the Parameter view.
→
Diagnostics Read the displayed message
→
Active
→
Save and restart the device.
The needed diagnostics are active.
English