Burkert Flowave 8098, Operating Instructions Manual

Page: 164 / 354

164
SAW sensor – Parameter
Type 8098 FLOWave L
Damping
level for
density
Damping level for mass flow rate
None Low Medium High Special
Medium • 15 s if the
Refresh time
is set to Long
• 10.5 s if the
Refresh time
is set to Short
or Very short
• 11 s • 20 s • 40 s • 10 s + User
defined Mass
flow response
time
High
• 35 s if the
Refresh time
is set to
Long
• 30.5 s if the
Refresh time
is set to Short
or Very short
• 31 s • 40 s • 60 s • 30 s + User
defined
Mass
flow response
time
Special • User-defined
Density
response time
+ 5 s if the
Refresh time
is set to Long
• User-defined
Density
response time
+ 1 s if the
Refresh time
is set to
Short
or
Very short
• User-defined
Density
response time
+ 1 s
• User-defined
Density
response time
+ 10 s
• User-defined
Density
response time
+ 30 s
• User-defined
Density
response time
+ User defined
Mass flow
response time
To set a predefined damping level of the measured mass flow rate values, do the following:
→
Go to the CONFIGURATION view.
→
SAW sensor
→
Confirm to access the Parameter view.
→
Stand. meas. values
→
Mass flow
→
Damping The Current settings are displayed
→
Choose a damping level between Low , Medium and High The New settings are
displayed.
→
Save.
The damping of the mass flow rate values is active and a predefined damping level is chosen.
English