Burkert Flowave 8098, Operating Instructions Manual

Page: 278 / 354

278
SAW sensor – Maintenance
Type 8098 FLOWave L
→
Calibration
→
Add. meas. values
→
Concentration 1
or
Concentration 2
→
Offset
→
Teach-in by reference The Current settings are displayed.
→
Start the calibration of the offset value.
→
After 30 s, enter the concentration of the reference liquid. The New settings
are displayed.
→
Save.
The offset value of the selected liquid concentration is calibrated.
If the calibration fails, a message is displayed. Refer to chapter 24.10 Messages due to calibration or
simulation.
→
Acknowledge the message to go back to the parent menu.
17.22 Setting the slope value of the liquid concentration
To enter a slope value for liquid concentration 1 or liquid concentration 2, do the following:
→
Go to the CONFIGURATION view.
→
SAW sensor
→
Confirm to access the Parameter view.
→
Go to the
MAINTENANCE
view.
→
Calibration
→
Add. meas. values
→
Concentration 1 or Concentration 2
→
Slope
→
Enter value
→
Set the slope value.
→
Save.
The slope value of the selected liquid concentration is set.
English